YT-73093 TrueRMS clamp meter 600 V 600 A
Description
TrueRMS function (use of root-mean-square value in measurements)
Automatic measurement range selection
With the clamps only current is measured.
Non-contact AC voltage detection by the inductive method in an insulated wire
DATA HOLD - saving the current measured value on the display
PEAK HOLD - hold of the maximum measured value on the display using test probes
INRUSH current - inrush current measurement with clamp jaws. The meter will measure current for 100 ms from the moment the device starts.
LCD display, maximum displayed result: 6000
Button for switching on screen backlight of the torch
Automatic switch from diode test to continuity check when circuit resistance is below 50 Ohm
Acoustic signal in the continuity check circuit for resistance below 50 Ohm
Clamp opens up to 25 mm
Probes length 14.5 cm, cable length - 97 cm, insulated wire diameter: 3.5 mm
Automatic meter shut-off after 15 minutes of inactivity (this function can be disabled)
Low battery indicator
Warranty for manufacturing defects, including measurement accuracy and successful passing of Uzstandart metrological verification: 12 months
Power supply: two 1.5 V batteries (AAA)
Case included
Automatic measurement range selection
With the clamps only current is measured.
Non-contact AC voltage detection by the inductive method in an insulated wire
DATA HOLD - saving the current measured value on the display
PEAK HOLD - hold of the maximum measured value on the display using test probes
INRUSH current - inrush current measurement with clamp jaws. The meter will measure current for 100 ms from the moment the device starts.
LCD display, maximum displayed result: 6000
Button for switching on screen backlight of the torch
Automatic switch from diode test to continuity check when circuit resistance is below 50 Ohm
Acoustic signal in the continuity check circuit for resistance below 50 Ohm
Clamp opens up to 25 mm
Probes length 14.5 cm, cable length - 97 cm, insulated wire diameter: 3.5 mm
Automatic meter shut-off after 15 minutes of inactivity (this function can be disabled)
Low battery indicator
Warranty for manufacturing defects, including measurement accuracy and successful passing of Uzstandart metrological verification: 12 months
Power supply: two 1.5 V batteries (AAA)
Case included
| Weight, kg | 0.396 |
| Capacity | 0-60 mF (±5%) |
| AC voltage, V | 0-600 TRUE RMS (±1%) |
| DC voltage, V | 0-600 (±0.5%) |
| Transistor test, hFE | IF 5mA, UR 3V |
| Continuity test | 0-50 Ohm |
| Resistance | 0 - 60 (±1.5%) |
| Temperature, °C | -30-1000 (±2.5%) |
| AC current, A | 0-600 (±2%) TRUE RMS |
| DC current, A | 0-600 (±2%) |
| Frequency, Hz | 0-10 MHz |
Other items in this section
